Case Studies

News on 17 Feb , 2015

NanoProtect acknowledges our valued clients’ case studies. The following provide compelling evidence that NanoProtect rovides the multitude of solutions our clients have depended upon.

It produces a large range of products which are stored in the company’s warehouses. Many of the products are temperature sensitive and must be stored at temperatures of less than 25°C. In order to satisfy Good Manufacturing Practice (GMP) requirements, the temperatures in the warehouses are continuously monitored in three zones: under the roof, mid warehouse, and near ground level.

The Problem

High summer temperatures resulted in the roof heating up, in turn heating up the air space underneath. This resulted in temperatures in the upper levels of the warehouses rising to 40°C in January 2013. The effect of this on the operation were:

  1. Temperature sensitive stock had to be re-allocated to cooler parts of the warehouse. This involved unnecessary movement of product and updating of warehouse records.
  2. Temperature activated extraction fans were installed in the roof to try and keep temperatures down.
  3. There was a risk of product spoilage if the temperature rose above 25°C.
  4. Heat transfer through the warehouse roof meant the air conditioning plant in the manufacturing and office areas contained within and adjacent to the warehouse consumed more electricity in order to keep these areas cool.

The Solution

In late April 2013 Pacific Pharmaceuticals decided to apply a NanoProtect Radiant Heat Barrier Coating to the warehouse which stores most of the heat sensitive product. The objective was to reduce the heat transfer through the roof, and lower the under-roof temperatures on hot summer days. The warehouse roof area was approximately 1,000 square metres. NanoProtect NZ Ltd was contracted to supply and apply the NanoProtect coating.

NanoProtect is a water-based emulsion of acrylic resins and ceramic beads. The ceramic beads give the product its heat barrier properties so that a 0.5 mm coating acts like a mirror to the heat of the sun. Additionally, NanoProtect will extend the life of a metal roof by converting rust into iron phosphate and preventing further corrosion.

After water-blasting the roof, the NanoProtect Heat Barrier Coating was applied in two coats with an airless spray gun to give a final coating thickness of 0.5 mm.

The Results

The benefits of coating the warehouse roof with NanoProtect have been dramatic. The extraction fans which would normally switch on when the underroof temperature reached 25°C have not operated at all since the application.There has been no need to move stock around the warehouse and disrupt normal operations.

Analysis of temperature records from April 2011 to April 2014 of the coated and uncoated warehouses shows the affect of the NanoProtect coating has been to reduce the peak roof temperature by 10.9°C. Prior to the NanoProtect application ( January 1999 ), monthly peak roof temperatures rose to 37.8°C. ie 8.4°C above the peak control temperature in the adjacent warehouse. After application ( January 2000 ) the monthly peak roof temperature was only 29.6°C. This was 2.5°C below the control temperature in the adjacent warehouse. Monthly average roof temperatures have been reduced by between 0.3°C and 15°C.

Leave a Reply

Your email address will not be published. Required fields are marked *